SAE J 1061


Surface Discontinuities on General Application Bolts, Screws, and StudsSAE International / 01-Feb-2008

This SAE Recommended Practice defines, illustrates, and specifies allowable limits for various types of surface discontinuities that may occur during the manufacture and processing of bolts, screws, and studs in sizes through 24 mm or 1 in diameter inclusive with lengths to 150 mm or 6 in inclusive, having specified minimum tensile strengths of 900 MPa or 120 000 psi and greater, which are primarily intended for use in automotive assemblies.The recommended practice does not include inspection sampling requirements other than for referee purposes.

Add to Cart:

  • Model: ALBL1VRG
  • 8888 Units in Stock

This product was added to our catalog on Thursday 01 January, 1970.

Your IP Address is:
Copyright © 2018 Buy Standards.